JD VIP Buyers Club
JD on Facebook
JamestownTV
JD Points Program
Request A Free Catalog

West System - Adding Fillers & Additives


Fillers

Throughout this and other West System manuals, we refer to "epoxy, neat epoxy or resin/hardener mixture," meaning mixed resin and hardener without fillers added; and "thickened mixture or thickened epoxy," meaning mixed resin and hardener with fillers added. Fillers are used to thicken epoxy for specific applications such as bonding or fairing.

After selecting an appropriate filler for your job (see Filler Selection Guide), use it to thicken the epoxy mixture to the desired consistency. The thickness of a mixture required for a particular job is controlled by the amount of filler added. There is no strict formula or measuring involved-use your eye to judge what consistency will work best. Figure 5 gives you a general guide to the differences between neat (unthickened) epoxy and the three consistencies referred to in this manual.

Always add fillers in a two-step process:

1. Mix the desired quantity of resin and hardener thoroughly before adding fillers. Begin with a small batch-allow room for the filler.
2. Blend in small handfuls or scoops of the appropriate filler until the desired consistency is reached (Figure 4).

For maximum strength, add only enough filler to completely bridge gaps between surface without sagging or running out of the joint or gap. A small amount should squeeze out of joints when clamped. For thick mixtures, don't fill the mixing cup more than 1/3 full of epoxy before adding filler. When making fairing compounds, stir in as much 407 or 410 as you can blend in smoothly-for easy sanding, the thicker the better. Be sure all of the filler is thoroughly blended before the mixture is applied. Spread the mixture into a thinner layer, either around the inside of the mixing cup or onto a flat non-porous surface or palette, to extend its working life.

Epoxy can be thickened to the ideal consistency needed for a particular job. The procedures in this manual refer to four common consistencies: syrup, catsup, mayonnaise and peanut butter.

Syrup SYRUP  
CONSISTENCY: Unthickened mixture
CHARACTERISTICS: Drips off vertical surfaces
USES: Coating; wetting-out before bonding; applying fiberglass, graphite and other fabrics
Catsup CATSUP  
CONSISTENCY: Slightly thickened
CHARACTERISTICS: Sags down vertical surfaces
USES: Laminating/bonding flat panels with large surface areas, injecting with a syringe
Mayonnaise MAYONNAISE  
CONSISTENCY: Moderately thickened
CHARACTERISTICS: Clings to vertical surfaces; peaks fall over
USES: General bonding, filleting, hardware bonding
Peanut Butter PEANUT BUTTER  
CONSISTENCY: Maximum thickness
CHARACTERISTICS: Clings to vertical surfaces; peaks stand up
USES: Gap filling, filleting, fairing, bonding uneven surfaces

Additives

Additives are used to give epoxy additional physical properties when used as a coating. Although additives are blended with mixed epoxy in the same two-step process as fillers, they are not designed to thicken the epoxy. (Refer to Additive descriptions) Follow the mixing instructions on the individual additive containers.

West System

For guidance choosing epoxy additives see
West System Filler Selection Guide

JD on Facebook Live Tech Support JD Customer Photo Gallery Free Catalog