JD VIP Buyers Club
JD on Facebook
JamestownTV
JD Points Program
Request A Free Catalog

Bonding polyethylene with West System Epoxy


Bonding a skeg to a polyethylene kayak


By Chris Maples

NOTE: This article predates the release of G/Flex epoxy which is ideal for bonding plastics


The hull shape of a white water kayak is not designed for tracking well in open water. Since I do most of my kayaking on open water and flatter rivers, I decided to mount a skeg on the hull to make it track better. This is pretty simple if you own a wood or fiberglass boat, but can be more challenging on a polyethylene kayak.

This is the situation I was faced with. Low energy surfaces such as polyethylene can be difficult to bond to with epoxy. However, using the proper techniques can ensure successful bonding. These are the steps that I used to bond a skeg to my boat, beginning with good surface preparation.

  1. I first sanded the polyethylene surface. Using coarse sandpaper, such as 80-grit, keys the surface and allows for good mechanical bonding. I allowed for plenty of bonding surface. Although my skeg is only an inch wide and 18" long, I prepared a bonding area several inches wide on either side of the skeg.
  2. I then flame treated the polyethylene surface after sanding. To flame treat a plastic surface, hold a propane torch flame about 4" to 6" from the plastic (with the tip of the flame just above the surface) and move it across the surface at a rate of 2 or 3 inches per second overlapping the previous pass slightly. Keep the torch moving and only allow the exhaust gases to hit the surface. If done correctly, the surface will not discolor or burn in any obvious way. This technique oxidizes the surface and improves adhesion. For best adhesion, bond to the surface within 30 minutes of treatment.
  3. I cut the shape of my skeg out of Styrofoam to match the aft end of the hull. The bottom shape of the skeg can be adjusted after it is bonded in place. The shape is designed to provide good tracking without being too deep.
  4. I bonded the foam skeg to the prepared hull surface with thickened epoxy and ran fillets the length of the skeg on either side.
  5. I used staggered layers of fiberglass cloth to build the foam-cored skeg. One layer of fiberglass covered the foam skeg and the entire bonding surface. The next layer of cloth covered the skeg and extended over the fillets. The final layer of cloth simply covered the bottom of the skeg to improve abrasion resistance. This staggered arrangement of the fiberglass allows for some flexibility of the mounted skeg.

The finished skeg, painted to match the kayak, has seen some abuse and has held up well.

The kayak has been used on a few rivers in Michigan and the skeg has seen its share of abuse. Scraping against rocks and running over fallen trees has not affected the adhesion of the skeg to the polyethylene hull.





Epoxyworks 16 / Fall 2000


Copyright 2002, Gougeon Brothers, Inc. All rights reserved.
Reproduction in any form, in whole or in part, is expressly forbidden without the consent of the publisher. EPOXYWORKS, Gougeon Brothers, WEST SYSTEM, Episize, Scarffer and Microlight as used throughout this publication, are trademarks of Gougeon Brothers, Inc., Bay City, Michigan, USA.


west system brand logo

JD on Facebook Live Tech Support JD Customer Photo Gallery Free Catalog