JD VIP Buyers Club
JD on Facebook
JamestownTV
Request A Free Catalog

How to Measure Teleflex Control Cables




Technical Reference Manual



How to Measure Control Cables



"Measure Twice. Order Once."
For a New Installation: Measure cable routing path from control head attachment point to engine connection, as follows:

Outboards:

Measure from control along unobstructed cable routing to center of outboard. Add four feet to allow for loop which provides unrestricted engine move ment. Round up to next whole foot and order required cable part number. (Last two digits of cable part number equal cable length in feet.)


Inboards & Stern Drives:

Measure from control along unobstructed cable routing to shift and/or throttle connection. Round this dimension off to the next whole foot and order required cable part number. (Last two digits of cable part number equal cable length in feet.)


For Replacement of Existing Cable:

If you removed the old cable, measure for replacement cable as follows:

Measure from tip to tip and round up to next whole foot, if necessary (aftermarket cables are sold in foot increments).

The control cable part number contains its length Teleflex cables are usually listed as CC???XX, where XX = length in feet. Morse cables are listed as ??????-??-XXX.0, where XXX.0 = length in inches.

For example:

Part Number CC63320 = 20 ft. CC633 Control Cable or Part Number 032377-03-240.0 = 20 ft. 33C Control Cable (240" = 20')



If you need further assistance, please contact Teleflex Marine Technical Service at 610-495-7011 visit us on-line at www.teleflexmarine.com.



JD on Facebook Live Tech Support JD Customer Photo Gallery Free Catalog