||One-component enamel based on alkyd / urethane resins
||Eggshell finish for interior use on wood, steel, fiberglass and aluminum in conjunction with the appropriate primer systems. For maintenance of existing, intact interior finishes.
||Quick drying, smooth hard satin finish with beautiful, long-lasting protection. Resistant to water, alcohol, most onboard chemicals and abrasion.
||60 +/- 2 vol. %
||Per coat wet - 60 micron
Per coat dry - 35 micron
||Brush, roller, conventional air spray, H.V.L.P., airless.
|Drying times at 65F / 65% RH
||Tack free - 3 hours Tape free - 24 hours
Dry - 12 hours Recoatable - 24 hours
|Thin as needed with Epifanes Brush Thinner For Paint & Varnish up to 5%.
Conventional air: Thin as needed up to 15% with Epifanes Spray Thinner for Paint
& Varnish. Spray viscosity 20 - 24 seconds Din Cup 4. 16 - 20 seconds Ford Cup 4.
Nozzle 1.5 mm - 1.8 mm. Pressure 2 - 3 Bar.
||Epifanes Accelerator, Epifanes Retarder
||Epifanes Eggshell Enamel is best used as a finish coat over a build-up of Epifanes Yacht Enamel, Monourethane, Two-part Polyurethane or, Nautiforte. Eggshell Enamel can be used over most other types of one-component alkyd or urethane based paint and over properly sanded two-component paints. See appropriate application and preparation instructions. Coverage approx. 140 sq. ft./liter.
||Temperature should be between 50F. and 85F. during application. Air humidity below 85%. Avoid painting in too much wind or sun. A rapid loss of solvents will occur under these conditions and will decrease the flowing ability. Add thinner up to the specified percentage to compensate for the faster release of solvents.