Print This Page
Customers most agreed on the following attributes:
Comments about Buck Algonquin Thru Hull Step Wrench 1/2 inch - 1-1/2 inches:
I found it very useful both to put in thru hulls and also to remove them - I don't know why the manufacturer says it is not suitable for removing thru hulls. It's robust, heavy duty and does what it's designed for.
from US Virgin Islands on 1/19/2009
Comments about Buck Algonquin Thru Hull Step Wrench 1/2 inch - 1-1/2 inches:
If the thru-hull is old, its knobs/keys that the wrench locks into may be gone. Then the wrench is useless and you either try vice grips or a grinder and grind off the ring of the TH. For an install, the tool was VERY helpful to tighten the TH from the outside where there was not room for a wrench on the inside nut.
from Green Cove Springs, Florida on 8/21/2008
Comments about Buck Algonquin Thru Hull Step Wrench 1/2 inch - 1-1/2 inches:
You can put a wrench on it without any problem.