Cole Hersee Continuous Duty Solenoid

Cole Hersee Continuous Duty Solenoid with two (2) 5/16"-24 threaded studs for battery & motor, two (2) 10-32 threaded terminals for activation & ground, silver contacts, and a 200 Amp carry rating.

Dimensions: 8mm x 15.1mm Mounting Slots-56mm apart on center.

This item is no longer available.

The item was added to your wishlist.

The item was added to your shop cart.

SOLENOID TYPES

Many remote mount solenoids look identical on the outside.
However, they can be very different on the inside. Beside the different internal circuits, these can be rated for continuous duty or intermittent duty use.

Continuous duty solenoids are wound with very fine wire and draw very little amperage. The contacts in continuous duty solenoids will usually have a lower amperage rating than that of the intermittent duty type. These are normally used as tilt trim relays. This type of solenoid can also be used for a variety of applications where a remote relay is needed to power a motor or other device.

Intermittent duty solenoids are wound with much heavier wire and draw more amperage. The contacts have a very high amperage rating. If these stay energized for extended periods of time they heat up and eventually burn out the coil inside the solenoid. This type of solenoid is normally used as a starter motor relay.