We are committed to delivering
the perfect order - on time and hassle free.
Fast and reliable -- Jamestown Distributors will ship anywhere in the world.
Attwood Flush Mount Fuel Tank Vents are made of 316 grade marine stainless steel for an attractive appearance and the ultimate in corrosion protection. Vents may be flush mounted on hulls up to 7/8 inches thick, and are compatible with 5/8 inch fuel hoses. Flush mount design prevents damage caused by other fuel vents with protruding caps.
Straight and 90 degree configurations are available.
$27.04
$32.33
The item was added to your wishlist.
The item was added to your shop cart.
BRAND:
Attwood
Metal:
Stainless Steel 316
Type:
Tank Vents and Valves
Questions & Answers about Attwood Flush Mount Fuel Tank Vents:
Comments about Attwood Flush Mount Fuel Tank Vents:
Like the vent. Built well. The 1 3/8 hole was no problem. Some hole saw arbors you can mount the 1 3/8 hole saw then mount the smaller hole saw on the inside of the 1 3/8 that fit the origial hole. The smaller hole saw will stick out allowing you to use it to center the hole. Just use a little care.
Was this a gift?:
No
6/14/2011
(7 of 7 customers found this review helpful)
5.0
Very nice !!
By Phil
from North East, MD
About Me Casual/ Recreational
Pros
Easy to Use
Protects Well
Visually Pleasing
Cons
Best Uses
Engine
Outdoor
Comments about Attwood Flush Mount Fuel Tank Vents:
I love the way these look on my boat and since they are flush, they don't interfere with hanging fenders. I used 2 straight vents for my black water and fresh water tanks and a 90 for my fuel tank. My old vents were plastic and they were corroded and broken. You will need a 1-3/8 hole saw if your hole is not big enough to install these vents. It is difficult, if not impossible, to center the hole saw without a pilot hole, so I cut down the flange of one of my old vents and used the old vent to pilot the hole. These come with a rubber gasket for the inside and out. I used 3M 4200 to seal the outside and the fiberglass where I cut through the gelcoat and used only the one gasket on the inside. The center of the vent is removeable to clean or replace the screen once the vent has been permanently installed. This was a much easier install then I thought. I replaced 3 vents in about 15 minuits once my pilot was made.
Was this a gift?:
No
12/8/2009
(2 of 2 customers found this review helpful)
4.0
Nice look
By Jim
from Sandusky, Ohio
About Me Recreational
Pros
Visually Pleasing
Cons
Best Uses
Engine
Comments about Attwood Flush Mount Fuel Tank Vents:
Well made, nice finish, works well. Requires a larger hole than the typical vent it replaces, which is a little problem using a hole saw to drill a bigger hole, as there is no pilot hole to center the saw on. Overall makes a nice smooth appearance on the hull side, nothing for fenders or lines to catch on.
Price Match Promise:
If you find a lower delivered price on a new identical item in stock and available for purchase from an authorized U.S. merchant.
- email us at pricematch@jamestowndistributors.com. This offer does not include special coupons or other promotional offers.
Special order items are not stocked and are ordered direct from the manufacturer. They are non-returnable, may take 2-4 weeks, price and shipping charges subject to change.
Checkout: 
Item(s) in your cart:
The item was added to your wishlist.
