Epifanes Wood Finish Matte Varnish

Wholesale Marine and Building Supplies

All Videos How Tos

Within Results

To be used over four coats of Gloss Wood Finish. This interior/ exterior finish provides beautiful rich extraordinary protection. Low gloss matte varnish. It is a non sanding solution for a matte finish. Its a one component varnish alternative based on urethane alkyd resins and tung oil, and contains UV absorbers. Wood Finish Matte is specially formulated for oilly woods like teak.

Technical Specifications:

Container Size: 500 ml., 1000ml.

Color: Opaque in the can, dries clear amber

Gloss: Matte (Some Sheen)

Density: 0.95 kg./liter

Solids Content : 40 +/- 2 vol. %

Drying times at 65F / 65% RH: Tack free - 1 hours / Tape free - 24 hours, Dry - 12 hours / Recoatable - 12 hours

Recommended Film Thickness: Per coat wet - 60 micron / Per coat dry - 25 micron

Application: Brush, roller, conventional air spray, H.V.L.P.

Temperature should be between 50 degrees F and 85 degrees F with the air humidity below 85 percent. Avoid varnishing in too much wind or sun. A rapid loss of solvents will occur under these conditions and will decrease the flowing ability. Add thinners up to the specified percentage to compensate for the faster release of solvents. Any existing finish much be intact, degreased and sanded prior to recoating. Before applying each coat, degrease the surface with Epifanes Spray Thinner or Denatured alcohol. Use a tack cloth to remove dust particles prior to application. Always stir Epifanes Wood Finish Matte before using. Failure to do so may result in an uneven or blotchy finish. Some settling of the formulation may occur upon long standing.