APPLICATION AND USE
Preparation
BARE WOOD/FIBERGLASS: Surfaces must be dry and free or dirt, oil, grease, paint, sanding residue or other contaminants. Where possible, abrade surface with coarse sandpaper or emery cloth. Clean with Special Thinner 216.
Method Work material into all voids, on very wide or deep seams a second application may be necessary. Try to achieve a smooth, fair patch. Apply to a maximum depth of 1/8 of an inch.
Hints
Thinning: Do not thin.
Cleaner: Special Thinner 216.
Other: To avoid flat spots when applying and sanding fillers on curved surfaces, use a spreader and sanding board that is longer than the width of the area by half as much again. For screw holes and small repair areas, over fill the area slightly to allow you to sand back to a flush finish.
Some Important Points No matter how smooth a finish you have achieved, when filling or fairing, all fillers must be sanded before overcoating to ensure good adhesion. Product temperature should be minimum 10 C/50 F and maximum 29 C/85 F. Ambient temperature should be minimum 10 C/50 F and maximum 35 C/95 F. Substrate temperature should be minimum 10 C/50 F and maximum 29 C/85 F.
Compatibility/Substrates Use on clean, dry, sanded bare wood or fiberglass surfaces only. Do not apply over painted surfaces. Only use with single part primers and finishes.
Number of Coats As required
Coverage (Theoretical) - 60 (sq ft/Gal) yields 60 mils
Application Methods Knife
TRANSPORTATION,STORAGE AND SAFETY INFORMATION
TRANSPORTATION: Surfacing Putty should be kept in securely closed containers during transport and storage.
STORAGE: Exposure to air and extremes of temperature should be avoided. For the full shelf life of Surfacing Putty to be realised ensure that between use the container is firmly closed and the temperature is between 5 C/40 F and 35 C/95F. Keep out of direct sunlight.
DISPOSAL: Do not discard tins or pour paint into water courses, use the facilities provided. It is best to allow paints to harden before disposal. Remainders of Surfacing Putty cannot be disposed of through the municipal waste route or dumped without permit. Disposal of remainders must be arranged for in consultation with the authorities.
Checkout: 
Item(s) in your cart:
The item was added to your wishlist.
