MetlWeld is a super tough two-part equal volume ratio epoxy adhesive, designed to bond metal and other dissimilar materials such as stainless steel, galvanized steel, aluminum, copper, glass, ceramic neoprene rubber and most porous services.
It will cure at temperatures as low as 50°F, and cures easily at room temperature. MetlWeld is pre-thickened so no additional fillers or bulking agents are needed to make it a non-sagging adhesive. Allow 48 hours for full cure and complete strength.
$20.47
$44.89
$99.82
$149.26
$253.95
$1,290.20
The item was added to your wishlist.
The item was added to your shop cart.
Technical Specifications
Mix Ratio by Volume: 1:1
Mix Ratio by Weight: 100:91
Total Solids: 100 percent
Mixed Viscosity: 320,000 cps
Mixed Color: Gray
Maximum Service Temp: 170 degrees F
Pot Life at 77 degrees F: 30 Minutes
Tack Free at 77 degrees F: 4 hours
Sheer Strength
Lap Sheer Strength Aluminum-Aluminum: 2,150 psi
Lap Sheer Strength Cold-Rolled Steel: 2,240 psi
Lap Sheer Strength Galvanized Steel: 1,820 psi
Use protective gloves when working with this product. Use soap and water or white vinegar to clean off of your hands. Use Denatured Alcohol to clean off your tools.
BRAND:
System Three
Material:
Epoxy
Number Of Parts:
Two Part
Type:
Epoxy Adhesive
Questions & Answers about System Three Silvertip Metl Weld:
2011-12-01JEREMY S asked: is metlweld ok to use on my dirtbike gas tank it metal. is meltweld hold up to gas?......Hope so just bought some
+Expand Answers
2011-12-30ALBERT ALMEIDA: Wow! I don't know about gas.
Get a small metal container that you can throw away after and add a puddle of Metl Weld on the bottom. Wait the 48 hours for it to cure then pour enough gas to cover the Metl Weld and see what happens. If you're not in a hurry, leave it in for week to see if it softens up.
It's a good product. I first tried it on 2 pcs of flat sheet metal for a test. After it was cured, I had to bang the hell out of it with a hammer and chisel to seperate them but it took awhile..........Good luck.
2011-09-02A shopper asked: I was thinking about getting this to repair a dent in an aluminum storm door. Would this work, and is it paintable?
+Expand Answers
2011-09-06STUART SEYMOUR: Meti Weld is very similar to JB Weld except a lot stronger. I think it would work OK. It is paintable.
Price Match Promise:
If you find a lower delivered price on a new identical item in stock and available for purchase from an authorized U.S. merchant.
- email us at pricematch@jamestowndistributors.com. This offer does not include special coupons or other promotional offers.
Special order items are not stocked and are ordered direct from the manufacturer. They are non-returnable, may take 2-4 weeks, price and shipping charges subject to change.
Checkout: 
Item(s) in your cart:
The item was added to your wishlist.
