Get Free Shipping on your order now! Don't miss out!
MENU
$0.00
CLOSE
Anchoring and DockingCleaning and PolishingElectricalEngine RoomEpoxy and AdhesivesFastenersFiberglass and Building MaterialsHardwareJD ApparelPainting SuppliesPaintsPlumbingStorage and WinterizationTools
BACK
Anchors and ChainBuoys and FendersCleatsDock AccessoriesDock HardwareFlotation SafetyGunwale GuardsRope and Running RiggingSwim Platforms and Boarding LaddersWindlasses and Accessories
TotalboatProduct SupportProject GuidesJDPro
Login Shopping Cart
Home / Anchoring and Docking / Cleats
Attwood

Attwood Neat Cleat

Ask a Question
$80.56In StockSee Product Details
Attwood Neat Cleat
Options
Quantity
1 ea contains 1 ea

This item is eligible for free shipping
This item will require additional time to ship

Product Details

The Attwood Neat Cleat retracts into a flush slim profile, making it perfect for narrow gunwales. A gentle pull snaps it up into active cleat mode and stays up. Retracts to only 1/2 inch above deck. No more snags or snubbed toes. Installation requires underneath access to threaded nuts.

Available in 4 and 6 inch lengths, and made of high-quality 316 grade stainless steel for an attractive appearance and the best possible corrosion protection.

Opening: 1-1/4 inches

Data Sheets
Neat Cleat Tech Specs
VIEW
Neat Cleat Installation Guide
VIEW
Recommended Products
Attwood Heavy Duty Herreshoff Cleat
Attwood
Attwood Heavy Duty Herreshoff Cleat
Starting at $65.27
Attwood Countersunk Flush Cleats
Attwood
Attwood Countersunk Flush Cleats
Starting at $99.40
Seachoice Pull Up Cleat
Seachoice
Seachoice Pull Up Cleat
Starting at $73.30

Reviews for Attwood Neat Cleat

1 of 1 Reviews

July 1, 2014

Good Product
By Bob from Cape Cod MA

Verified Purchase

Good product, easy to install. Specs say drill 1" holes for 6" cleat. The cleat is very loose in 1" holes. If you set the cleat in 5200 and tighten the nuts appropriately it should not move, but unless you do that, it could conceivably shift under load. Before installing the second cleat I tested 7/8" holes in scrap wood and it work perfectly. Sung but not too tight. Be very accurate in measuring of the holes as there is no wiggle room to align the cleant when using a 7/8" hole saw. The instructions call for an extra deep socket to tighten the nuts which I did not have. I used an under sink wrench basin wrench instead. You'll need a very large extra deep socket, greater than 1" otherwise. I never measured the nuts but I'm guessing 1 and 1/8" to 1 and 13/16". The largest socket I had on hand was 1" and it was too small.

Bottom Line Yes, I would recommend to a friend
Was this review helpful to you?
24/7 Support

Need help or have questions? The FAQs in our Help Center cover most account, order, or product-related topics. Click to call or chat with our Total Support Team.

Help Center
or call 1.800.497.0010