This item is eligible for free shipping on orders over $99.99
This item will require additional time to ship
Black, heavy-duty rubber replacement gaskets for Bomar extruded and cast hatches are available in two models perfect for replacing old, cracked, ineffective rubber gaskets. Round profile (9/16 in. D), adhesive-backed gaskets are for Bomar ports and cast hatches. Molded (3/8 in. D), low-profile gaskets are for Bomar extrusion hatches. Both models are available in 5 ft. and 10 ft. lengths.
|BOM-P2000255||Molded, low-profile gasket for Bomar extrusion hatches||3/8 in.||5 ft.|
|BOM-P20002510||Molded, low-profile gasket for Bomar extrusion hatches||3/8 in.||10 ft.|
|BOM-P100525||Round, adhesive-backed gasket for Bomar ports and cast hatches||9/16 in.||5 ft.|
|BOM-P10055||Round, adhesive-backed gasket for Bomar ports and cast hatches||9/16 in.||10 ft.|
August 4, 2021
Perfect fit for a older Bomar hatch, good instructions, easy install. A minor point to keep in mind, to finish, you need to cut a butt joint, make sure you have a VERY sharp knife to do this, so it is a clean cut, I might also suggest putting a touch of silicone sealant in the joint, just my two cents worth.
July 5, 2020
Thanks for the good service.product was exactly as described although a little pricey. Shipping time was good thanks again
May 27, 2020
Order was sent fast and correctly
May 19, 2020
My port lights are too old (late 80s) so unfortunately these gaskets did not work. The return process was easy
April 19, 2018
The self adhesive strip made applying the gasket simple. A tapered cut and dab of glue sealed the ends where they meet.
August 29, 2017
when installing the new gasket material does the lens slide into the lip and then you use contact cement on the top of gasket and glue it to the top frame?
June 23, 2017
I would like to see a photo of the low profile hatch. I only see the round one. I ordered the one that was supposed to be for the large hatch 95009611 but it was the round gasket and doesn't fit.
August 8, 2013
Make sure you thoroughly clean the old material off and use Isoprop. Alcohol to clean the area before installing or else the adhesive will fail. I had no issues.
Phasellus suscipit tincidunt tristique. Quisque mattis euismod ipsum, ac accumsan ante fermentum non. Vestibulum eget auctor lorem. Integer euismod justo nulla, nec ultricies ipsum pulvinar in. Duis sed fringilla turpis, at ultricies orci. Nam est turpis, consequat nec feugiat a.
Praesent sodales et ipsum
Mauris congue justo sit amet lacus sagittis, a tempor lectus tempus. Suspendisse quis nulla ac nibh accumsan tincidunt ac quis tortor. Proin dignissim aliquam odio, sed bibendum urna sagittis dapibus. Aenean ut tristique ante, sit amet ultrices nisi. Praesent eu dapibus augue. Mauris tempus suscipit ipsum, et malesuada tellus euismod eu. Quisque consequat turpis id feugiat lacinia. Vestibulum sit amet elementum augue. Quisque tempus ligula vitae placerat pulvinar. In egestas sodales lorem, id egestas lacus pharetra eget. Sed ac mi placerat, placerat nulla ut, imperdiet nunc. Mauris at felis vehicula, commodo est eu, ullamcorper purus.