Awlgrip AwlQuik Primer / Surfacer Converter D9001
This item is eligible for free shipping
Awlgrip AwlQuik Primer / Surfacer Converter D9001 is a quick-drying, medium build, easily sanded, two-component epoxy primer/surfacer. Easy to apply by brush, roller or spray. Not to be used below the waterline. (Topside only)
Mixing and Reduction - Spray: Mix by volume 1 part D8003 base with 1 part D9001 until a smooth homogenous mixture is obtained. Reduce as necessary up to 50% with spray reducer T0006.
Brush/Roll: reduce mixed D8003/D9001 as needed up to 50% with T0031.
Induction time after mixing is 15 minutes.
Pot life is 8 hrs at 77 F/50% relative humidity.
Application Instructions:
Spray - apply Awl-Quik sanding surfacer in smooth coats of 4 to 6 mils (100-150 microns) WFT yielding 2-3 mils (50 to 75 microns) DFT. Allow 4 hrs between coats at 77 F/50% RH.
Brush/Roller - Two coats will be required. Light sanding between coats will improve appearance. For large surfaces rolling, then tipping with a brush is preferred.
Do not apply to surfaces less than 3 C/5 F above the dew point, to surfaces warmer than 41 C/105 F, or when ambient temperature is outside the range of 13 C/55 F - 41 C/105 F.
Technical Information
- Type: Epoxy Polyamide
- Packaging: Available in 1 gallon and 1 quart containers.
- Theoretical Coverage: Sq. Feet/Gallon 609 Sq. Feet at one mil dry. 203-305 Sq. Feet at recommended dry film thickness.
- Calculated for mixed base and converter reduced 50%.
- Coverage calculations are based on theoretical transfer efficiency of 100%
- Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and application environment.
- Recommended Wet Film Thickness: 5 mils (125 microns)
- Recommended Dry Film Thickness: 2-3 mils (50-75 microns)
- Recoatability: At 77F/50% R.H.
- Spray: may be overcoated with itself, 4 hours; with 545 Primer or topcoat, 12 hours.
- Brush Roll: with itself, 12 - 14 hours, with other products 12 - 14 hours.
- Maximum without sanding: 24 Hours. May be overcoated with AWLGRIP/AWLCRAFT 2000 Topcoats,
- VOC: Base 436 g/lt or 3.6 lbs/gal. Converter 354 g/lt or 3 lbs/gal