This item is eligible for free shipping on orders over $99.99
This item will require additional time to ship
The Tie Down Engineering Galvanized Inside Corner should be used with one of the outside corners listed below. The Inside Corner has elongated holes for easy fit-up and measures 8-1/2 inches long on each leg and is 5 inches high.
The Inside Corner End fastens to the inner corner of the dock with eight (8) 3/8" Galvanized Carriage Bolts. Use with the Galvanized Outside Corner (Item No. TIE-26523 or TIE-26402) to provide for sturdy dock construction.
The Inside Corner End may also be used with the Galvanized Female T-Connector (Item No. TIE-26528 or TIE-26407) and the Galvanized Male T-Connector (Item No. TIE-26522 or TIE-25491) to reinforce the corners of hinged dock fingers and ramps.
Tie Down Dock Hardware is available in both Standard Grade (3/16") and Commercial Grade (1/4") hot-dip galvanized steel for corrosion resistance and long life.
Tie Down Dock Hardware is designed for use with 1-1/2" thick lumber (minimum width 6"). All hardware is mounted with 3/8" Galvanized Carriage Bolts. All Male and Female dock-to-dock hinged connections are made with either 3/4" Galvanized Bolts with lock nuts or 3/4" quick disconnect Galvanized Connector Pins (Item No. TIE-26531).
The Tie Down Dock Hardware Building Plans will provide you with several designs for building a lightweight and long lasting floating dock system.
(See the "Links" tab above for a pdf copy of the Dock Hardware Building Plans.)