This item is eligible for free shipping on orders over $99.99
Use Awlgrip Awl-Prep Surface Cleaner T0008 to wipe down final primed or topcoated surfaces before and after sanding. T0008 is a mild surface cleaner and degreaser that will remove hand oils, light grease and other light surface contaminants. It has a "drying" effect that removes latent moisture from the surface, which can cause a gloss finish to come out flat. T0008 is photochemically reactive.
Use the two rag method to effectively clean with this product, to get rid of all the containments on the surface of your project.
Surface Preparation - A clean, dry surface is essential to the success of any coatings application. Remember to clean before sanding. Sanding often melts greases and oils into the surface, making it difficult to obtain a clean surface.
Care should be used when wiping primed or painted surfaces which are not fully cured. Awl-Prep wipe down products can attack an epoxy or urethane coating as well as some polyester fillers which are not yet fully cured. Usually an epoxy or urethane surface which be sanded is cured enough to be wiped down with Awl-prep surface cleaning solvents, but not de-waxing or degreasing solvents. Polyester fillers are often sensitive to the types of solvents in the AWL-PREP product line. Always check a small area before beginning the two cloth method on a primed or topcoated surface.
Detergent Scrubbing - Many applicators scrub the surface they are goin to paint with household cleanser and a 3M Scotchbrite Pad before any other prep work is performed. This is an excellent practice as careful observation of the rinse water will tell you when you have a clean surface. Breaks, holes, or beading of the rinse water indicate area which need additional cleansing.
Application Instructions - Two Cloth Cleaning Method.
Surface should be clean of all dust. Use a vacuum to removed ust or use clean dry compressed air to blow while wiping with clean, oil free, dry cotton cloths. A majority of dust and dirt should be removed before wiping down with an Awl-prep wipe down solvent.
Soak one cloth in the Awl-Prep solvent. Wet the surface with this cloth.
Use a dry second cloth to wipe the surface dry and lift the contamination off the surface. Work in small areas (4 sq m or less) to keep the surface cleaner from drying before the second rag wipes the surface clean and dry. Repeat until surface is residue free.
Warning Wiping with one wet cloth only smears contamination around. Be sure cloth used is clean. Surface must be dry before using tack rags.