Free shipping on orders over $99.99! Don't miss out!
$50.85 Limited Stock
Buck Algonquin Bronze Angle Plate Oarlock Socket
$50.85Limited Stock
Bronze Angle Plate Oarlock Socket
Ask a Question
4
Based on 2 Reviews
  • 5 Star

    0%

  • 4 Star

    100%

  • 3 Star

    0%

  • 2 Star

    0%

  • 1 Star

    0%

Buck Algonquin Bronze Angle Plate Oarlock Socket Customer Questions and Answers

1 of 1 Questions

Question

what size screws do we use to mont these sockets ?

Asked on 02/12/2012 by Undisclosed

Top Answer

A #6 screw can be used with no protruding head. #8 screw head sits flush with 2 of the holes, but I had to further countersink the other holes to get the screws to sit flush (or recessed a little).

Answered on 02/14/2012 by walter bailey
See More Answers (6)

Answer

I used #8 by 1" bonze screws.

Answered on 02/14/2012 by DAN MCCORMACK

Answer

Hi I did buy some bronze screws from you as well at the same time There ¥Ë_¥Ë_¥Ë_was some recomendation for size, somewhere but 1/4 diameter counter sunk head or flat is more a question of tast. Look at my records from 2010 or was it 2009. I still have some screw left. Hope It helped - An advise is to grind an polish the surface really well they will come out very nice, the same is for the oarlocks. You can look at may home page the swedish edition on"material" there I have them on my Rangeley lakeboats. Perhaps you like some of the pictures. www.batbyggeriet.eu the english side is not as detailed as the swedish. Best regard Bjorn

Answered on 02/13/2012 by BJORN THAFVELIN

Answer

I used size #10 flat-head silicon bronze screws, 1.5" long. You should have at least 1.5" length for 3 vertical screws. Horizontal length will depend upon thickness of your gunwales. You can always cut the 1.5" screws shorter to fit.

Answered on 02/13/2012 by MARK SEGRAVES

Answer

I used #10, 1-1/4" silicon bronze. The screw heads fit well in the holes of the oarlock sockets. Of course, length would depend upon the thickness of the material into which you're mounting them.

Answered on 02/13/2012 by RICHARD LATTIMER

Answer

Look at what you are attaching the oar lock too. I used #8x1 1/4 screws as the gunnel permitted this thickness witthout penetration accross it. If it were thinner, I would use #8x1 inch screws. Predrill holes for screws with a 1/8 bit to avoid breakage of brass screws. If you have steel screws of the same size and thread, pass them first to cut the thread in the hardwood of the gunnel, then use the brass screws in their tract. As I remount the oar locks frequently in my guide boat going from solo use at mid ship to double use with the rower in the bow. To avoid stripping the threads, I harden the established threads with a few drops of crazy glue once the screws are out and take care to manually start the screws in the same track to avoid cutting new threads and stripping them.

Answered on 02/14/2012 by ROBERT DAVIS

Answer

I used oval slot head brass #8 1 1.2 inch wood screws.

Answered on 02/13/2012 by ROLF ETHUN
Answer Question
1 of 1