Free shipping on orders over $99.99! Don't miss out!
$21.40 In Stock
Evercoat Polyvinyl Alcohol
$21.40In Stock
Write A Review
4.3
Based on 3 Reviews
  • 5 Star

    67%

  • 4 Star

    0%

  • 3 Star

    33%

  • 2 Star

    0%

  • 1 Star

    0%

Reviews for Evercoat Polyvinyl Alcohol

3 of 3 Reviews

August 17, 2021

I have bought this product again and again.
By Lady may from Delmar, De

Verified Purchase

When using soft sand with gel coat, the gel takes longer to cure. Why? I don't know.

October 31, 2012

Carbon fiber and fiberglass mold release
By madhellsing from uranus

It works great! It creates a film like a sheet of plastic that is great for molding carbon fiber spoiler brackets and fiberglass airsoft parts. All I use is a artist brush and you don't have to worrie about streak marks because it evens out and creates a uniform film. I also experimented spraying it on a larger mold and it works great if you know haow to spray so it doesn't build up or clog. When spraying do one to two passes at a time and let it dry before adding another pass. also between coats you should wax it carefully not to damage the film to ad extra release. I wax before applying and after 3 build up coats I wax again and coat over it. you can sumerger the mold in hot water so the film just desintegrates and your parts releases super easily. NOte: Try not appling on a humid environment because it would cause the film to bubble up and create air pockets that would make for an uneven furface. Also let dry after each coat completely before applying another so the film doesn't get damage and clog up. I love this is just a bit expensive though.

April 19, 2010

Sticky, hard to spray
By horgun from new york

Hard to spray over the repaired surface, because it dries into a cloggy mess. Probably a trick to it, that I don't know. Once you get it on the repair, it dries into a film that does seem to promote curing. You can peel some of it off, afterwards, but you have to sand or scrub off the rest. There must be an easier way...

1 of 1