Free shipping on orders over $99.99! Don't miss out!
$54.53 Limited Stock
Pettit Tie Coat Primer 6627
$54.53Limited Stock
Pettit Tie Coat Primer 6627, metal primer, boat bottom primer
Ask a Question
5
Based on 1 Reviews
  • 5 Star

    100%

  • 4 Star

    0%

  • 3 Star

    0%

  • 2 Star

    0%

  • 1 Star

    0%

Pettit Tie Coat Primer 6627 Customer Questions and Answers

3 of 3 Questions

Question

what is the Maximum recoat time?

Asked on 03/29/2015 by Rick Kay

Top Answer

Temperature is the key. At 70 you can recoat in 2 hrs and top coat in 4 so starting early you can get it done in the day. At 50 you have a problem. You might want to do this work just before you get ready to launch. I have to finish priming and painting my deck. I can't do it yet because its not warm enough yet so I'll wait. I have lots of other things to do that aren't temperature sensitive. Good luck.

Answered on 03/29/2015 by Michael Horowitz
See More Answers (3)

Answer

Thanks for the answer. My concern was not enough hours in the day to do the 6455/044 and several coats of 6627 to get the 10 mils. and then get on a coat of bottom paint. Since the 6455/044 has a 48 hr topcoat time can the 6627 and bottom paint be done the second day?

Answered on 03/29/2015 by Rick Kay

Answer

The can just lists minimum recoat times depending on temperature. There is no mention of a max, so if it's just been a day or two you're probably ok; however, if it's been a long time you might want to check with Pettit.

Answered on 04/01/2015 by DENNIS DUNN

Answer

You have to read the label. If you wait past the time you have to sand it. Instead of worrying about te maximum amount of time you should be more concerned with the minimum, or shortly after. You want both a chemical and mechanical bond. If you wait too long you lose the chemical bond. That being said, it solved my problem of my old finish flaking off and new paint adhered very well.

Answered on 03/29/2015 by Michael Horowitz
Answer Question

Question

I plan to apply this Tie Coat Primer on a wood hull (marine plywood) coated with CPES Penetrating Epoxy. Pettit's instructions for bare wood call for 25% thinning with Pettit 97 Epoxy Thinner. Does this apply in my case as well with the wood sealed with Penetrating Epoxy?

Asked on 04/29/2021 by Pags from Duluth, MN

Top Answer

No. Follow the instructions for fiberglass.

Answered on 05/01/2021 by Paul
Answer Question

Question

I want to paint my mast as simply as possible after using alumniprep 33. Does Petit 6455 metal primer followed by petit 6627 tie coat primer, then petit easypoxy sound OK? Jim

Asked on 01/26/2012 by Undisclosed

Top Answer

I have not used Tie Coat on metal. I did use it under Hydrocoat to prime bare wood. I tried the spec thinner (12097) but it evaporated too fast. I then used alcohol for thinning with good success. Don't panic when you pour in the alcohol and it turns into cottage cheese - just stir well. The Hydorcoat works great at least in New England with just a coat a year and more than a month between application and launching.

Answered on 02/06/2012 by ROGER DEMLER
Answer Question
1 of 1