By signing into your account, you represent that you have read and agree to our Terms and our Privacy Policy
Can this fuel gauge be used for automotive use?
Asked on 06/29/2014 by UndisclosedDon't see why not. We purchased one for a gas tank assembly we had to build for a Onan generator system onboard a taco truck, the gas tank we used was off a vehicle.
Answered on 06/29/2014 by ERIN HALTOMI would certainly think so.
Answered on 06/30/2014 by BRYAN ATWOODI don't know why not. It should work fine with any 12 volt system.
Answered on 06/29/2014 by WILLIAM BRISSETTEwhat diameter hole is needed?
Asked on 06/14/2013 by Undisclosed2" hole required
Answered on 06/19/2013 by THOMAS DAWSONI have forgotten in that was over a year ago. I just measured the gauge with a ruler.
Answered on 06/14/2013 by BRYAN ATWOODI bought the dash mount and had great sucess with install. I works very well with the moeller 12 gal tank. The hole required for the mount is 2 and 1/16. Then route the hole slowly to give it a snug fit. May have to route about 1/16. Mine fit very snug. Will not come out
Answered on 06/17/2013 by RONALD POORMANWHAT IS THE OUTSIDE DIAMETER OF THE HOUSING?
Asked on 04/20/2015 by UndisclosedIt was installed 3 years ago. I don't remember the size.
Answered on 04/21/2015 by BRYAN ATWOODWhite part of case is 1.985" Black circumference around face 2.22" Measured by calipers
Answered on 04/20/2015 by STEVE DESROSIERS IICan it be installed in the cockpit? Is it waterproof?
Asked on 07/30/2018 by Val from New JerseyYes, and yes (water resistant, you may have issues if it is submerged to a degree) .
Answered on 07/30/2018 by JD Tech AssociateWhat are the dimensions? I am only extending an existing gauge. Will this suffice?
Asked on 02/27/2014 by Greg Deaton2" diameter Hole.
Answered on 02/27/2014 by Rick WhiteI have a Auto Meter 33 F Ohm Cat # 200760. Will this work for my Moeller 13 gal gas tank?
Asked on 08/05/2013 by Ruben MoncadaI assume your wondering if your gauge will work with the new sending unit I would think its likely hook up the sending unit before you put it in the tank and simulate full/empty tank or contact the manufacturer
Answered on 08/06/2013 by THOMAS DAWSONBy signing into your account, you represent that you have read and agree to our Terms and our Privacy Policy