AwlGrip Ultra Build two component epoxy primer has excellent sag resistance and excellent film build/filling capability. Use with other AwlGrip primes where high build and filling is required above the waterline.
*** FOR PROFESSIONAL USE ONLY ***

Info & Guides

Apply via conventional or airless spray. Pressure feed equipment is required.

This product should only be applied over other properly prepared Awlgrip Primers.

Mixing and Reduction - Mix by volume one part D8008 with one part D3018 to a smooth homogenous mixture. Reduce 5%-25%with T0073 for conventional spray, but airless spray requires no reduction.

Application Instructions - Apply in smooth, even coats, allow one hour between coats at 77 F/50% RH.

Note: Do not apply more than 2 coats without allowing to cure hard, 12 to 24 hours. Do not apply paint materials to surfaces warmer than 105 F or colder than 55 F.

Technical Information

Type: Epoxy Polyamide
Packaging: Available in 1 gallon and 1 quart containers
Theoretical Coverage: Sq. Feet/Gallon 946 Sq. Feet at one mil dry
47-63 Sq. Feet at recommended dry film thickness
Calculated for mixed base and converter reduced 10%.
Coverage calculations are based on theoretical transfer efficiency of 100%.
ctual coverage rate obtained will vary according to equipment choice, application techniques, part size, and application environment.
Recommended Wet Film Thickness: 25-30 mils (625-750 microns)
Recommended Dry Film Thickness: 15-20 mils (375-500 microns)
Recoatability: May be overcoated with 545 Primer, HIGH BUILD Primer, SPRAYABLE FAIRING Compound, AWL-FAIR® L.W., and AWL-QUIK®.
Minimum with itself, 1 hour; other products, 12 hours. Maximum without sanding 24 hours. Sanding before overcoating with other products is recommended.
VOC: Base D8008 496 g/lt or 4.1 lbs/gallon
Induction time after mixing: 15 minutes
Pot Life is 8 hours at 77 F/50% relative humidity

Data Sheets

Ultra Build Epoxy Primer Tech Data

VIEW