This item is eligible for free shipping
This item will require additional time to ship
Rule LoPro LP900 low profile bilge pumps measure just 2 1/4'' high. These ultra compact pumps make it easier to configure effective bilge water removal solutions in tight spaces.
Available in both manual (LP900D) and fully automatic (LP900S) models, both with 900 GPM (gallon per hour) pumping capacity. Pump bodies rotate 180 degree for easy installation in narrow areas. Threaded discharge nozzles include both 90 degree and straight fitting (with check valve to prevent backflow). Mount in horizontal or vertical position.
The fully automatic LP900S model features two modes: one engages the pump when the water level is 1.3 inches or 2 inches; the second mode engages the pump briefly every 2 1/2 minutes to check for and remove detected water.
SPECIFICATIONS | LP900S | LP900D |
---|---|---|
Automatic | Yes | No |
Flow Rate | 900 gph | 900 gph |
Port Types | Includes hose fittings: One 3/4" Straight, one 3/4" 90 degree, one 1" Straight, and one 1-1/8" Straight | Includes hose fittings: One 3/4" Straight, one 3/4" 90 degree, one 1" Straight, and one 1-1/8" Straight |
Voltage | 13.6 V DC | 13.6 V DC |
Amperage | 4 A (approximately) | 4 A (approximately) |
Fuse Size | 7.5 amp | 7.5 amp |
Length | 9.3" (23.7 cm) | 7.6" (19 cm) |
Weight | 1 lb (0.45 kg) | 1 lb (0.45 kg) |
Hose Included | No | No |
Submersible | No | No |
Technical Information
<b>Features</b>
- LP900S is fully automatic, featuring multiple modes of operation to safeguard your boat from potential flooding
- LP900D is manual and requires a float and/or panel switch
- Fully rotating discharge body allows easy installation in awkward places
- Multiple ports to increase compatibility across a variety of vessels
- Tricuspid check valve helps prevent backflow, keeping your boat dry
- Horizontal and vertical mounting options accommodate the design of any type of boat
Reviews for Rule LP900 LoPro Bilge Pumps
Verified Purchase
An ABYC certified technician could not get it to work after 3 hours. It cost me $300 in labor for nothing and that is not refundable. Returned, and the Jamestown tech said other pumps returned with similar problems. Buy only if you want your boat to sink
Was this review helpful to you?
I purchased to replace another low profile pump. After 3 hours of having an ABYC technician install it properly, pump would not prime or operate no matter what was done. Tried O-ring grease to improve seal but still no success. Had to buy another pump at the local marine store to make sure there was an operable bilge pump.
Was this review helpful to you?