Attwood Neat Cleat
Attwood Attwood Marine Logo
  • Attwood Neat Cleat

Attwood Neat Cleat

The Attwood Neat Cleat retracts into a flush slim profile, making it perfect for narrow gunwales. A gentle pull snaps it up into active cleat mode and stays up. Retracts to only 1/2 inch above deck. No more snags or snubbed toes. Installation requires underneath access to threaded nuts.

Available in 4 and 6 inch lengths, and made of high-quality 316 grade stainless steel for an attractive appearance and the best possible corrosion protection.

Opening: 1-1/4 inches

 
IN STOCK
$68.75 / ea
qty.   
$68.75
$74.42
 The item was added to your wishlist.
 The item was added to your shop cart.
Tech Spec Product Info User Generated Content
BRAND: Attwood
Metal: Stainless Steel 316
Type: Popup Cleats
5.0 1

Good Product

5

Good product, easy to install. Specs say drill 1" holes for 6" cleat. The cleat is very loose in 1" holes. If you set the cleat in 5200 and tighten the nuts appropriately it should not move, but unless you do that, it could conceivably shift under load. Before installing the second cleat I tested 7/8" holes in scrap wood and it work perfectly. Sung but not too tight. Be very accurate in measuring of the holes as there is no wiggle room to align the cleant when using a 7/8" hole saw. The instructions call for an extra deep socket to tighten the nuts which I did not have. I used an under sink wrench basin wrench instead. You'll need a very large extra deep socket, greater than 1" otherwise. I never measured the nuts but I'm guessing 1 and 1/8" to 1 and 13/16". The largest socket I had on hand was 1" and it was too small.

Bob

Cape Cod MA

true

Attwood Neat Cleat

5.01

100.0

Related Items:
TotalBoat Blogs Live Tech Support