Vetus rubber exhaust hose meets Lloyd's standards for flexible exhaust hose and has the toughness required to withstand hot exhaust gases from marine engines. Double stainless steel helix braid prevents hose collapse, while smooth bore interior provides a flush and smooth surface to minimize any back pressure. More flexible type of rubber construction makes for easy installation.
The item was added to your wishlist.
The item was added to your shop cart.
Exhaust hose with Internal Diameter of up to 6 inches has a bending radius of no more than 1.5 x the diameter of the hose.
Exhaust hose with Internal Diameter over 6 inches has a bending radius of 2 x the diameter of the hose.
Exhaust hose is sold in three increments
6 foot section
12 foot section
priced per coil.
is this wire reinforced corrugated hose it says braided?
I honestly don't remember. About a year ago.
Thank you for your response
Yes, this is a wire reinforced corrugated hose.
What I do remember is that it was very easy to work with and seems more than strong enough. It was to replace the hoses on the diesel engines. Replaced with same brand.
Is hose good for wet exhaust systems?Listing does not specify like Shields hose listing
Yes, the hose good for wet exhaust systems
what is the hottest temp these hoses can stand?
They are rated between -22deg and 212deg F. With a short peak at 239deg F.
This hose was much easier to install than I had feared, much easier to put on the new hose compared to getting the hold one off.
New Smyrna Beach, FL
VET-SLANG40-6 Exhaust Hose Rubber 1-9/16
The product was fine but we were charged tax. Since it was an out of state purchase, we shouldn't have been charged tax.
Just what I needed
a little hard to cut and get a nice finished and square end. Remember to use two hose clamps on each end