TotalBoat Epoxy Resin
System Three SilverTip Laminating Resin
System Three System Three
  • System Three SilverTip Laminating Resin

System Three SilverTip Laminating Resin Kits

SilverTip Laminating Resin is designed specifically for laminating. It is a med-low viscosity, liquid epoxy system that has been optimized for coating and reinforcing fabric saturation in wood-composite boatbuilding. Fast wet-out, no blush, and cures to a brilliant, colorless finish.

Working time is longer than most boat building epoxies, without sacrificing cure time. Cured film is tough and resilient with better heat resistance than other room temperature cured epoxies.

Each SilverTip kit includes 1 gallon of laminating resin, 1/2 gallon of either fast or slow hardener and a set of calibrated plungers for dispensing.

This item is no longer available.
 The item was added to your wishlist.
 The item was added to your shop cart.
Tech Spec Product Info User Generated Content
    Technical Specifications
  • Mix Ratio by Volume: 100:50
  • Mix Ratio by Weight: 100:43
  • Total Solids: 100 percent
  • Mixed Viscosity: 700 cps
  • Mixed Color: Water White
  • Coverage: 150 square ft/Gal
  • Maximum Service Temp: 160 degrees F
  • Tensile Strength" 7,900 psi
  • Tensile Elongation: 8 percent
  • Flexural Strength: 420,000 psi
  • Flexural Modulus: 12,800 psi
  • Compressive Strength: 13,000 psi at yield, 26,000 psi at failure
  •   Pot Life at 77 degrees F  Tack Free Time at 77 degrees F 
    Fast  26 Minutes  3 Hours 
    Slow  60 Minutes  6 Hours 

    Use protective gloves when working with this product. Use soap and water or white vinegar to clean off of your hands. Use Denatured Alcohol to clean off your tools.

    BRAND: System Three
    Material: Epoxy
    Number Of Parts: Two Part
    Type: Resin
    Usage: Laminating
    4.5 2

    Clear finish, no yellow tint

    5

    I use decorative inlays of all shades of cedar and redwood on the decks of my cedar strip kayaks. The clear finish of Silver Tip resin allows the true color of the wood to come through. Definitely enhances the true beauty of the wood compared to other resins.

    Cedar strip boat builder

    Grand Junction, CO

    Yes

    This is my favorite epoxy.

    4

    Unless you need maximum strength, or ultra-low viscosity, this is the one to use. No blush, good strength, no post-cure required, and it doesn't trap bubbles. It will bond to bare glass extremely well. I just don't like the fact that it has an odd mix ratio (if you do it by weight, 100 parts resin to 43 part hardener).

    modulus 1319

    Green Bay, WI

    Yes

    System Three SilverTip Laminating Resin Kits

    4.52

    100.0

    Related Items:
    TotalBoat Blogs Live Tech Support Jamestown Forum Free Catalog