APPLICATION AND USE
FIBERGLASS OR GELCOAT: Wipe with Fiberglass Solvent Wash 202. Sand with 80 grade (grit) paper. Remove sanding residue.
CLEAR EPOXY: Wash down with fresh water. Sand with 80 grade (grit) paper. Remove sanding residue.
EPOXY PRIMERS: Sand with 80 grade (grit) paper. Remove sanding residue.
Method Mixed putty is usually applied using a troweling knife (putty knife) with a 3 inch blade. Draw out to a thin layer. Do not apply more putty than necessary. After an overnight cure, sand with the same grade sandpaper being used for the overall surface area, then apply two-part primer or polyurethane.
Mixing Mix both components together thoroughly to correct mix ratio.
Thinner Reducing Solvent 2316N. Brush Thinner 2333N.
Thinning Thinning is not necessary in most situations. If thinning is required for very thin film applications, use Reducing Solvent 2316N. Alternatively Brush Thinner 2333N can be used. The addition of thinner will cause shrinkage of Interfill Epoxy Filler.
Cleaner Reducing Solvent 2316N. Brush Thinner 2333N.
Other If Interfill Epoxy Filler is used below the waterline, it must be covered by at least 4 coats of Interprotect 2000E/2001E.
Some Important Points Do not apply more than 800 mils thickness at any one time. Do not use below 10 C/50 F. Product temperature should be minimum 10 C/50 F and maximum 35 C/95 F. Ambient temperature should be minimum 10 C/50 F and maximum 35 C/95 F. Substrate temperature should be minimum 10 C/50 F and maximum 35 C/95 F.
Compatibility/Substrates Do not use on traditional wood constructions where the wood will expand and contract through changes in the moisture content.
Coverage (Theoretical) - 8.1 (sq ft/Gal) @ 5000 micron (200 mil) WFT.
Recommended DFT 787.4 mils dry
Application Methods Batten, Trowel
TRANSPORTATION, STORAGE, AND SAFETY INFORMATION
GENERAL INFORMATION: Exposure to air and extremes of temperature should be avoided. For the full shelf life of this product to be realised ensure that between use the container is firmly closed and the temperature is between 5 degC/40 deg F and 35 deg C/95 deg F. Keep out of direct sunlight.
TRANSPORTATION: Interfill Epoxy Filler should be kept in securely closed containers during transport and storage.
DISPOSAL: Do not discard tins or pour paint into water courses, use the facilities provided. It is best to allow paints to harden before disposal.
GENERAL: Remainders of Interfill Epoxy Filler cannot be disposed of through the municipal waste route or dumped without permit. Disposal of remainders must be arranged for in consultation with the authorities.
Curing agent - WARNING:
Cancer - www.P65Warnings.ca.gov
Base - WARNING:
Cancer and Reproductive Harm - www.P65Warnings.ca.gov