Mix your own non-slip finish - Any Interlux topside finish (including Interthane Plus) can be transformed into a non-skid deck finish by the addition of Interlux Intergrip Polymeric No-Skid Additive. This additive consists of man-made plastic spheres, which are regular in shape. They have a low tendency to collect dirt, and excellent non-skid properties. Apply two coats of paint with Intergrip Polymeric No-Skid Additive mixed in. Intergrip comes in regular grit.
Hand Broadcasting Method - Roll on a coat of Interthane Plus, Brightside or Toplac and while it is still wet, sprinkle the Intergrip as required to obtain the texture of our choice. It is best to put the Intergrip in a flour sifter or salt shaker to dispense the compound. Avoid heavy application, which will not assist in providing a more slip resistant surface. After the paint has been allowed to dry overnight, remove the excess Intergrip and apply the second coat of finish.
APPLICATION AND USE
PREVIOUSLY PAINTED SURFACES:
In Good Condition: Wash down with Yacht Line Super Cleaner, rinse with fresh water and allow to dry. Abrade with 280-320 grade (grit) paper.
In Poor Condition: Remove all previous coatings and prime the substrate.
PRIMING: All preparation for bare substrates is covered on the appropriate primer datasheet.
BARE WOOD: Prime with Yacht Primer or UCP.
STEEL: Prime with Yacht Primer or Interprotect.
ALUMINIUM: Prime with Etch Primer followed by either Yacht Primer or Interprotect.
GRP: Wash down with Yacht Line Super Cleaner, rinse with fresh water and allow to dry. Abrade with 180-220 grade paper. No priming necessary. - If any filling is required use the appropriate product from the Interfill range.
Method Sand the primer with 180-220 grade wet or dry paper. Remove dust with a dust wipe. Apply 1-2 coats.
Mixing Stir well before use.
Thinner Thinners No.1 (YTA800)
Cleaner Thinners No.1 (YTA800)
Ventilation and Humidity Control Apply in dry, well ventilated conditions.
Other For best results either stipple by brush or use a mohair roller.
Some Important Points Product temperature should be minimum 10 deg C and maximum 30 deg C. Ambient temperature should be minimum 5 deg C/40 deg F and maximum 35 deg C/95 deg F. Substrate temperature should be minimum 5 deg C/40 deg F and maximum 35 deg C/95 deg F.
Compatibility/Substrates Suitable for all substrates and filled surfaces. Not suitable for permanently immersed surfaces. Do not clean with highly alkaline cleaners.
Number of Coats 1-2
Coverage (Theoretical) - 386.7 (sq ft/Gal)
Recommended DFT 2.0 mils dry
Recommended WFT 3.7 mils wet
Application Methods Brush, Rollerp
TRANSPORTATION,STORAGE AND SAFETY INFORMATION
GENERAL INFORMATION: Exposure to air and extremes of temperature should be avoided. For the full shelf life of Interdeck to be realised ensure that between use the container is firmly closed and the temperature is between 5 deg C/40 deg F and 35 deg C/95 deg F. Keep out of direct sunlight.
TRANSPORTATION: Interdeck should be kept in securely closed containers during transport and storage.
DISPOSAL: Do not discard tins or pour paint into water courses, use the facilities provided. It is best to allow paints to harden before disposal.
Remainders of Interdeck cannot be disposed of through the municipal waste route or dumped without permit. Disposal of remainders must be arranged for in consultation with the authorities.
WARNING: Cancer - www.P65Warnings.ca.gov