Episize Unidirectional Carbon Fiber Tape is used to improve tensile, compressive strength and stiffness in one direction while adding minimum thickness and weight. Reinforcing tape with fiber bundles held in place by a polyester fill thread for easy handling and wet out. .015" thickness.
Made by Gougeon Brothers (WEST System). Sold in pre-cut widths and lengths.
The item was added to your wishlist.
The item was added to your shop cart.
Carbon Fiber Tape
i have to redo the stringers in the bottom of a 1981 Gibson 36 foot houseboat.what product do you recommend to use? I herd you guys had the best stuff for the job
If you are looking to re-tab the stringers I'd recommend a fiberglass tape in a width wide enough to cover the stringer and the hull a few inches depending on the size of the stringer.Your best bet for strength would be to use 3 layers of a thinner cloth/mat than trying to do it in one big lay up. The thinner material is easier to work with as far as making the corners, and once layed up will be as strong if not stronger than a thicker single layer.
I plan to use the carbon fiber tape on each side of a thin fiberglass shelf that is under load, and currently has a crack in it. I plan to use epoxy to hold the carbon fiber in place, does carbon fiber get along well if covered under and over by epoxy?
Yes but it is thick so plan on having a large lump it does not fold well
Yes, epoxy, such as West System epoxy is perfect for carbon fiber tape. You should sand your fiberglass shelf where your carbon fiber will be added to get a good bond to the fiberglass structure.
Yes, that is an excellent application for carbon fiber. Epoxy will bond carbon and fiberglass (properly prepared).
Will this material adhere to a Red Hi Temp Silicon Seal application @ 600 degree ?
This is a technical question. Probably the only way to answer it is to try it. My suspicion is that the epoxy binding material will burn up well before you get to 600C.
I have no experience with Red Hi Temp Silicon so I can't help you. Hopefully others can.
Sorry, we haven't had any experience using this with hi temp bonding
once the carbon tape is applied , can I also add an adhesive to the tape for aditional strength?
It's not tape like duct tape is tape. It's carbon fiber weaved in narrow strips and needs epoxy along with it to work.
Bill,I used West Epoxy resin to adhere the carbon fiber tape to the wood pieces for extra strength in the vertical direction.Jay Graham Amityville NY
I employed carbon tape quite extensively in the restoration of a 1974 sail boat (laminated wood). The tape has been applied with epoxy west system as by instructions of the manual. Easy to handle and strong; I felt no need to apply any other adhesive. The boat has been used for raising since 2008, and I had no evidence od any problem.Maurizio Brunori, Rome
WILLIAM A. EATON
Yes you can, but you have to prepare the tape for secondary bonding, if the epoxy is hardened
Hello Bill,By adhesive, do you mean an epoxy resin?If so, this is a necessary part of the process. Also, to the best of my knowledge the term 'tape' refers to the dimension of the carbon fiber and not a self-sdhesive quality. You may also want to check if the tape is uni or bi-directional in weave. The weave, along with fiber density and with of tape will determine tensile strength.Hope this is helpful,Dale
Bill,We used epozy to adher the carbon fiber tape to the wood giving both wood and epoxy more tensile strength. In our case 1300 lbs of pull from harpe strings.Jim
Carbon Fiber tape
First time using carbon fiber. East to apply, wets out well, no issues.