- Use a soft, non abrasive applicator.
Surface Preparation - Rinse surface thoroughly prior to washing.
Mixing and Reduction - 1 ounce (30 ml) of Awlwash per each gallon (3.785 liters) of waters.
Application Instructions - Wash surface while still wet from initial rinsing, using a soft, non-abrasive applicator when washing the surface. Do not allow Awlwash to dry on the surface prior to rinsing. Wash small sections of large surfaces to insure the surface stays wet. Rinse after washing. Wipe with chamois or soft cotton towel to prevent water spots.
Note: If water spots are a problem, Awlgrip recommends using a water softener to reduce water spots. If water beads are allowed to air dry, water evaporation leaves residue on the paint. Remove the reside or risk eventual paint etching. Water spots can be removed with Awlgrip Awlcare protective polymer sealer. Stubborn stains may require a higher concentration of Awlwash. High concentrations require additional rinsing.
Note: Awlgrip recommends washing the surface once per week to prevent dirt buildup.
Optimal surface/ambient temperature range is 18 C/60 F to 35 C/95 F. Proper application and or cure results may be more difficult to achieve when temperatures are outside of this range. Do not apply to surfaces less than 3 C or 5 F above dew point, to surfaces warmer than 41 C/105 F, or when ambient temp is lower than 10 C/50 F or over 41 C/105 F.