A high density polyurethane foam roller, ideal for epoxy, paint and varnish applications. Can be cut into shorter widths to match the application area and cut into brushes for tipping off fresh coats of epoxy. Covers are 7-inches wide. Packages of two. Made by Arroworthy, professional grade brushing and roller products.
The item was added to your wishlist.
The item was added to your shop cart.
are these OK for epoxy primer and Urathane paints?
I did not use these for that. I used them for the West Epoxy. They are very thin, so they would be OK. You want a very thin roller so as not to have it soak up paint in the roller, it will drip down your hand if the roller has to much paint.
these work fine. easy to use. i would recommend these. thank you, roy
The rollers come apart - delaminate - in less than 3 minutes of rolling epoxy. I have tried to send Jamestown photos, but have not yet found a way. This is not a product Jamestown wants to sell.
Didn'T hold up
I was told these were the go to roller covers for epoxy. The worked fine for 10 minutes but then the foam starts to come loose.
Roller cover delaminated while using total boat epoxy primer
Friend was using one of my roller covers and it started to shed pieces of foam. A couple days later I was using one and it unrolled the foam from the base. When I peeled the foam off I found out that most of the surface was covered by very little or no glue - bad place to save money.
very poor quality. the foam is wrapped on like the cardboard roll of paper towels. bought 2 packs. out of the 4, only 1 had the edges of the foam close to each other, the others all had gaps of up to a 1/4".
Great for applying epoxy fill coat
These roller covers work great for epoxy. The thin polyurethane material doesn't introduce bubbles into the epoxy. I was able to use a single roller cover to epoxy-coat a 14.5 foot kayak hull.
I used these covers to apply epoxy primer to my boat's bottom. It's a fiberglass 27'. I could only get 1 coat on 1 side before the foam began to separate from the core. These covers did give nice, uniform coverage before the foam came loose. I purchased another package of covers from a different manufacturer and they worked much better.
Des Moines, IA
used with topside paint on sunfish
Easy to cut these covers on band sawto fit other size rollers
This can't be good.
Used to apply two-part epoxy primer and two-part polyurethane paint on aluminum mast, boom, spin pole.Foam covering separates from fiber core. To cover half the circumferance of my 66 foot mast would require 5 covers.Initially I cut the roller covers in half (3.5 inches) when rolling my boom. I thought this may have caused the problem. However, I got the same failure using a full size (uncut) roller cover on my mast.I switched to another brand of foam roller cover and was able to complete one full coat on my mast using only one roller cover.It's possible the curvature of the mast caused the foam covering to creep on the core and that this failure would not occur on large flat surfaces.