The Rule 25DA 12V round bilge pump is a light, compact pump for smaller vessels. For automatic operation use Rule Float Switches. It features a tough plastic body, quick release inlet strainer to allow rapid cleaning, and low amp draw to conserve batteries. This 500 gallon per hour pump is ignition protected. Replacement motor cartridges available.
Rule submersible pumps are installed by many boat manufacturers because they offer good performance at a great price. Their motors feature stainless steel shafts, water-cooling and a vibration-free centrifugal impeller that won t burn out if it runs dry. Each requires a panel switch for manual operation or a float switch for automatic operation.
The item was added to your wishlist.
The item was added to your shop cart.
Output: Up to 6 gallons/minute.
Designed for 19mm (3/4") hose.
Dimensions: 95mm high, 60mm base diameter.
Use 2.5 amp fuse
Bilge Pumps and Accessories
What is the diameter (ID) of the hose to be used for the output?
3/4" ID hose.
JD Tech Associate
I am wondering how high this pump can push water?
My pump supplies my bait tank. It pushes the water from a 2 ft. hose up 3 ft. I am not sure how much volume you need as the higher it pushes water the less volume you will get.
The one I had only had to push water about 2 1/2 ft. It did a super job at that height. Sorry I cant help you any farther than that. Good luck.David
According to Rule's documentation it can pump up to 12 feet, but at a very reduced flow rate. For example the 500 will only pump 250 gph 6 feet high, 125 gph 9 feet, etc.
Good product and economical
Being so small it is good to have a weighted base plate under it.