TotalBoat High Performance Medium Hardener is the curing agent for low-viscosity TotalBoat High Performance Epoxy Resin for most common applications, or if you need it to cure overnight at room temperature.
At 77°F, this non-blushing hardener has a pot life of 25 minutes, is tack-free in approximately 3 hours, and reaches full cure in 3-1/2 days.
Pairing TotalBoat High Performance Resin with the Medium Hardener results in a moisture-resistant solid that cures clear, ideal for clear coating applications. No blush to remove between coats means no time-consuming washdowns & no worrying about whether you removed all the blush, which could cause improper cure.
This Medium Hardener is available in Group Size A (pint), B (half gallon), and C (gallon), to match the group sizes of TotalBoat High Performance Epoxy Resin. This reduces waste and saves you money.
The item was added to your wishlist.
The item was added to your shop cart.
TotalBoat High Performance Epoxy Resin and High Performance Non-Blushing Hardener combine to cure to an ultra-clear, glossy, blush-free finish that produces exceptional results for hand layups, laminating, and clear coating.
Three Hardener Speeds Let You Control Pot Life and Cure Time
Fast, Medium, and Slow High Performance Hardeners allow you to control the pot life and cure times to suit your particular working conditions.
Even better, you can craft your ideal working properties and pot life by combining the different hardeners with each other, but always remember to maintain the proper ratio of 2 parts resin to 1 part hardener by volume.
Which High Performance Hardener Should I Use?
High Performance Fast Hardener - Use High Performance Fast Hardener for the fastest cure and shortest working time at room temperature, or for an overnight cure in low temperatures (minimum 55°F).
High Performance Medium Hardener - Use High Performance Medium Hardener for most common applications, or for an overnight cure at room temperature (77°F).
High Performance Slow Hardener - Use High Performance Slow Hardener for extended working time and cure time at room temperature, or when working in warmer temperature conditions. If you are new at working with epoxy resin, the slow speed hardener will give you more working time, which you may find helpful.
IMPORTANT! In order to achieve a proper cure, accurate mix ratios are critical when working with epoxy resin and hardeners.
TotalBoat High Performance Epoxy Resin and TotalBoat High Performance Hardeners can be measured either by pouring or by using the calibrated TotalBoat 2:1 Epoxy Pumps (sold separately). If using the pump method for dispensing, USE ONLY TOTALBOAT 2:1 Epoxy Pumps. DO NOT substitute the pumps from any other epoxy system or the material will not cure properly.
NOTE: The procedure for dispensing TotalBoat High Performance Epoxy Resin and TotalBoat High Performance Hardener properly is always ONE full pump of resin to ONE full pump of hardener.
High Performance Fast Hardener
High Performance Medium Hardener
High Performance Slow Hardener
Mix Ratio by Volume (Resin:Hardener)
Mix Ratio by Weight (Resin:Hardener)
Initial Mixed Viscosity at 77°F
Gel Time at 77°F (150g mass)
Tack-Free Time at 77°F
Full Cure at 77°F
Minimum Recommended Temperature
Hardness, Shore D
Intended for Clear Coating Applications?
Group Size A
TB-0221MA - TotalBoat High Performance Medium Hardener - 1 Pint
PERSONAL SAFETY: For your safety, please be sure to wear protective gloves and eye, face, and clothing protection when working with epoxy resin and hardeners. Also, be sure your work area has adequate ventilation, and that you wear a proper respirator.
Rate Of Cure:
Great product, very predictable.
Using a combination of slow, medium and fast hardeners in 46 sportfish major repairs in various weather conditions outside.Great support from the JD crew.I have ordered again and again.