Stainless steel bow chocks used to lead lines over port and starboard bow rails of a vessel while minimizing line and deck abrasion of working lines under load. These chocks are made of investment cast 316 stainless steel with the proper slant for a bow lead.
Available in two sizes and sold only in pairs. 4-3/4" requires (2) #10 flat head fasteners, and the 6" requires (2) 1/4" flat head fasteners for proper installation.
The item was added to your wishlist.
The item was added to your shop cart.
Stainless Steel 316
How far apart are the center points for the bolts on the 4/3/4" chocks?
3 5/16" center to center of the bolt holes.
I've already installed mine. But best I can see it looks to be 3 3/8" between bolt/screw centers.
By my measurement, hole center to hole center is 2.5 inches.
3 5/16" center to center.
Bolt holes center to center 3 7/8"
Bolt holes are 3 and 5/16 inches from center to center on the 4 and 3/4 chocks. Jerry
would buy and recommend this product
Installed on bow of my 17' center console as a fair lead for docklines and or anchor line.
Florida panhandle, on the Gulf coast.
use 1/4 inch fasteners for 6 inch chocks
The online product specs should include the hardware size. It is printed on the packaging card and would make ordering easier to complete the installation. These chocks are a very good value.
I would recommend this product
good looking item, solid stainless steel.
Nice product(s), except incorrectly cast "L" left and "R" right. "R" is actually port and visa versa.
Not much to say, other than were just what I was looking for for my boat. Needed stainless for salt water environment.