COVID-19 Update: We are open & shipping orders! We are working hard to ship as quickly as possible, while ensuring the safety of our associates. Please note: we have closed our Bristol retail store. Click for details
Jamestown Distributors(800) 497-0010
Click to watch the JD Search Tutorial video & learn
all about searching and browsing on Jamestowndistributors.com
Bronze Seacocks by Buck Algonquin are built with a Bronze body. The sea cocks have a hard chromed bronze ball, teflon rings, U.L. labeled, vinyl coated stainless steel handle that rotates 1/4 turn "On" and 1/4 turn "Off". Triangular base.
The item was added to your wishlist.
The item was added to your shop cart.
WARNING: Cancer and Reproductive Harm
Warning: this product contains a chemical known to the State of California to cause cancer, birth defects or other reproductive harm. Do not use in connection with drinking water. Wash hands after handling. For more information, go to www.P65Warnings.ca.gov
Seacocks & Ball Valves
Is the top thread straight or NPT. Do you have a tail piece with this thread to connect to a 1.5 inch hose. Do you have the through hull section that screws into the bottom of the valve.
Buck Algonquin does not state the thread type anywhere. You might have to give them a call to verify thread type. We do sell bronze tailpieces, and we generally stock the most common sizes (such as 1.5").
JD Tech Associate
Is handle in upward position to open seacock?
Yes, up is open
Yes. But as with most of these Seacocks - the handle can be removed and reattached with a different orientation should the need arise.
Yes. It couldn't face down because the hull would be in the way.
could you send me typical installation it is for a well pump?
Afraid I don't understand the application. I installed seacock in the hull of my boat and connected one to the galley sink and the other to the cockpit drain.There is an excellent detail and article in Wooden Boat magazine a couple issues back. Basically, you need a piece of wood to backup the seacock on the inside of the hull and the threaded part that passes thru the hull must be trimmed (cut) to the correct length so that the seacock flange is tight against the wood backup block. The seacock flange is through bolted to the wooden backup block and not the hull. Use lots of caulk.RC
I bought the 1-1/2" seacock for an overboard discharge. The quality seems good and the ball valve operates smoothly. It's super heavy
Rugged bronze construction
Buck Algonquin seacocks are well made hardware. I only use seacocks for below waterline thru hulls. Ordinary ball valves are a poor substitute and will not properly engage the straight threads of a typical thru hull. I don't believe in trying to cheap out this type of install.