I'm refinishing an old mackee craft. Rolled on two coats of primer sanding each coat lightly. Rolled on first coat of top side wet edge and it looks great. Now I'm rubbing it down and getting ready to roll on the second coat. Temps are 80's to 90's so I added maybe five percent thinner to the paint and only had perhaps two very small runs that I've easily scraped down level before the next coat. Paint was dry to touch in six hours so I could cover the boat at night without the paint sticking to the tarp. Beautiful, glossy finish that self leveled almost completely flat and smooth. Rolled on but looks as good as sprayed. Hopefully the next coat will go on as well and if I can handle the heat of summer actually apply a third coat for durability. Meanwhile I'm cussing all the angles in the boat that make it hard to apply paint evenly and the brush tipping doesn't smooth out as well as the roller. I'm having to use a small roller to handle most of the curves evenly and without ridges. Would buy again if the paint sticks well and holds up as good as they claim.

harold

cleveland tx.

I purchased this to paint where a fiberglass repair was completed and can't be more pleased with this paint! The details given are spot on and overall the finish looks great and seems to be holding up great! They even threw in a pair of gloves, pair of mixing sticks and some mixing cups to ensure the job could be done easily!

Capt Keith

Monroe, NC

Painted my boat but had to sand to bare metal and use their primer

Jack

Palm Coast, FL

I used the total boat topside in flag blue and white for my wood boat. I absolutely love the flag blue. Roll and tip and the result is a great glossy finish.

Drago

South shore New England

I like working with wet edge. It flows on easily and levels well. This was a youth project, and the kids put on the primer and first coat. Second coat by the adults largely covered and looked great. Perfectionist probably would probably go for a third coat, but the class schedule, etc., limited available time, and two coats looked swell. I like the easy cleanup with mineral spirits, too.

Paul356

Milwaukee

I found this product difficult to apply, I tried foam brush and high quality bristle brush and just could get the end result I was hoping for, even tried light coats and a heavier one. One point though I have it figured and then notice a bunch of sags 15 min later. Maybe in the right hands the results could be better, but I've been varnishing and painting arond boats for 35 years and this one had me stumped.

Dan

NY

Easy to apply and the finish is amazing!! Such a difference a couple coats of this topside paint can make. Our sail boat us 53 years old and looks brand new now. Thanks TotalBoat

'66 Chris-Craft Capri

Traverse City, MI

Did a boot stripe. Came out sweet, just as advertised.

Mjoseph

Rhode Island

I had the guy that painted my house also spray paint my travel trailer. It has fiberglass sides so this paint was perfect. Lots of prep to remove old graphics and rough up the fiberglass. We did one coat of gray primer, thinned 20% with xylene then two thin coats of kingston gray topside paint also thinned 20% with xylene. The results were fantastic. After it sets for a couple weeks we'll add graphics.

Capn' Steveo

Fullerton, CA

Roll and tip!!

LC

Mobile Alabama