awlgrip 30-y-94 epoxy primer, aluminum boat paint prep
Awlgrip Awlgrip
  • awlgrip 30-y-94 epoxy primer, aluminum boat paint prep

AwlGrip 30-Y-94 Epoxy Primer

AwlGrip 30Y94 primer is a two component anti-corrosive, strontium chromate epoxy primer for aluminum and steel with excellent chemical and solvent resistance. Do not use below the waterline. Should only be applied with a conventional or airless sprayer. AwlGrip S9001 and S3001
This item is no longer available.
 The item was added to your wishlist.
 The item was added to your shop cart.
Tech Spec Product Info User Generated Content
Surface Preparation
Aluminum - Sandblast/grind to 100% clean silver color or treat with Alumiprep 33/Alodine 1201. Steel: Sandblast/grind sspc-sp5-85 or Sa 2 1/2. Do not apply over Zinc Chromate Wash Primer.

Application Equipment Convention or airless spray.

Mixing and Reduction Mix by volume 1 part S9001 with 1 part S3001. When a smooth homogenous mixture is obtained, reduce up to 50% with T0006. Overall mix is 1:1:1 by volume.
Tip: You will get a smooth application by inducting the mixed S9001/S3001 30-45 minutes before adding the reducer. Stir the S9001/S3001 mixture every 10-15 minutes while inducting.

Induction Time After Mixing 15 minutes

Anticipated Pot Life At 77 F/50 relative humidity, 8 hours.

Application Instructions Spray only. Apply one smooth wet coat. Cross coating or double coating is acceptable on very tough surfaces. Substrate may be visible through the dry film. Too thick a film may split and peel. Do not apply to surfaces warmer than 105 F or colder than 55 F. Do not attempt to cure at temperatures below 55 F.


  • Theoretical Coverage: Sq. Ft./Gallon: *298 Sq. Feet at one mil dry
  • Theoretical Coverage: Sq. Ft./Gallon: 198-496 Sq. Feet at recommended dry film thickness
  • *Calculated for mixed base and converter, reduced 50%.
  • Coverage calculations are based on theoretical transfer efficiency of 100%.
  • Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and application environment.
  • Recommended Wet Film Thickness: 3-7.5 mils (75-175 microns)
  • Recommended Dry Film Thickness: 0.6-1.5 mils (15-37 microns)
  • Recoatability: At 77F/50% R.H. minimum 2-4 hours. Maximum without sanding is 24 hours.
  • Plan your work schedule to eliminate having to sand 30-Y-94TM.
  • May be overcoated with AWLGRIP/AWLCRAFT 2000 Topcoats, 545 Epoxy Primer, High Build Epoxy Primer, AWL-QUIK Sanding Surfacer, and ULTRA-BUILD Epoxy Primer.
  • VOC: Base 685 g/lt or 5.7 lbs/gal. Converter 515 g/lt or 4.3 lbs/gal
  • Type: Epoxy Polyamide meets Mil-P-23377D standard


BRAND: Awlgrip
Number Of Parts: Two Part
Type: Primer
TotalBoat Blogs Live Tech Support