Cable thru hull fittings are designed to let antenna and electronic wires pass through the hull without letting water in. These Seachoice fittings are self attaching and require no hardware. Each one accommodates up to 2 wires while still maintaining a watertight seal. Installation of fittings requires a 3/4 inch (1.9cm) hole and can only be used on boats with a hull thickness of 2 inches or less. Available in Black or White.
The item was added to your wishlist.
The item was added to your shop cart.
will this still work with a one inch hole i have already drilled?
Jack .thanks for the reply...i may have the same problem then....my radar cable is .47 inches wide, sounds like it will not fit thru the fitting either.
yes Remi, this through hull fitting will work on a 1" hole. The problem I had was the connector on my transducer cable will not fit through the through hull fitting. I was unable to use it, but if you are able to put the cable end fittings on after you pass it through the fitting, I think it will be a "dy-nomite" application. Hope this gives you a little insight.Jack
nice idea but slot is too small for transducer cable.
to small for cable wish they would make different sizes
The shipping charge was redicules and it only weighed 1.2 pounds and it took 12 days to get here . I ordered a simuler prodect the same day from someone else and it was only 7 dollers not 12 to ship and it got to my house in 4 days I didnt like the way it was shipped through the ups and then the post office . It sat all weekend at the post office wich is less than 1 mile away and they would not let me have it so i had to wait untill they delivered it . I would not buy anything from you again for that reason NEVER NEVER NEVER AGAIN Todd .