We've made Thixo even better! Thixo Fast Cure is stronger and cures over three times faster than standard Thixo. This 2:1 thickened epoxy adhesive provides the same great benefits. 185ml cartridges fit standard caulking guns. Simple point-and-shoot dispensing lets you apply a bead of Thixo Fast Cure with a squeeze of the handle. Included mixing tips ensure the correct ratio of resin to hardener, and eliminate messes or waste.
Fast Cure is ideal for bonding applications above and below the waterline, as an adhesive on wood, metal, or fiberglass. Note: It is not appropriate for use as a Gap filler and cannot be applied with a material thickness over 1/2." Cartridges sold individually with 2 mixing tips included. Additional mixing tips are sold in pairs or quantity of 12.
Sandable & ready for high loads in only four hours.
The item was added to your wishlist.
The item was added to your shop cart.
Hardness, Shore D
Tensile Strength (psi)
Tensile Modulus (psi)
Tensile Elongation (%)
HDT, Post cured (deg F)
Compressive Strength (psi)
Flexural Strength (psi)
Flexural Modulus (psi)
Tensile Adhesion (wood) (psi)
Tensile Adhesion (aluminum) (psi)
Tensile Adhesion (G10) (psi)
Resin Density at 77 F (lbs/gal)
Hardener Density at 77 degrees F, lbs/gal
Resin Color - A
Hardener Color - B
Thixotropic Index, 1/10RPM
Mix Ratio by Weight
Mix Ratio by Volume
Gel Time at 77 degrees F, 150 gram mass, min
Vertical Sag Resistance, in.
Number Of Parts:
Rate Of Cure:
Question on your TotalBoat Thixo Fast Cure 2:1 Epoxy System (THIXOFC-K) are the tips reusable? And the mixing of the resin and hardner happens in the tips right?
No. They are not. Order the multi pack of tips.
The tips are not reusable. They fill up with cured and partially cured adhesive.Mixing of the resin and hardener happens in the tip, so you don't need to mix it in another container after dispensing.Be careful to dispose of the tips in the trash after use and don't get the uncured or partially cured adhesive on your skin.This message has been marked as Medtronic Controlled
I haven't tried reusing a tip. It appeared to mix a little ways from the very tip so I think it would probably kick over. I bought a bunch of tips... I have had good luck with using one tube over several months on smaller applications. The stuff is awesome.
The mixing of the resin and hardener occurs in the tips so after a while,the contents inside the tip will harden.
The tips are not reusable.Â The mix happens in the tips.Â Be sure to have a strong caulking gun as the mix is stiff.
No the tips are not reusable, but the main body is.So make sure you order some extra tipsðŸ˜‰
Hi There,The tips are not re usable as the epoxy will harden inside them. When mounting the tip, I have found it worth while to be sure both resin side and hardener side are squeezed up full before hand. Sometimes there can be a bit of space on one side or the other. I had a small area of a fillet which did not harden well because of this. The partial tubes can be re capped and last quite well.
No the tips are not reusable, and yes the mixing takes place in the tips.
As far as I know they cannot be reused.The mixing does indeed take place in the tip, the two parts are spiraled around and mixed (an ingenious idea).BTW, it takes a lot of hand force on the calking applicator handle to squeeze the epoxy through the tip, perhaps an electric caulking applicator would be a good thing.Since the tips and tubes of epoxyÂ are rather expensive, and the tips non reusable I have gone back to mixing epoxy from gallon jugs in plastic cups and applying with a flat stick, much cheaper and more control over epoxy by adding thickeners to each batch. Of course I'm usually mixing small batches for small boats.BD
Hi Wayne, the solvent and time that it would take to clean a tip enough to reuse is not financially viable. It's just not worth it. We understand the issue and so we send all Thixo products with 2 tips with each tube. More tips can be purchased separately as well. The mixing tip is full of little chambers and as the resin and hardener flow through the static mixing tip, they mix adequately for application.
JD Tech Associate
The tips are single use.
why can this product not be used to fill gaps?
Because it cannot be applied over 1/2" thick because it will generate heat as it cures at thicknesses over 1/2", use the regular Thixo not the Fast Cure.
JD Tech Team
Will this product work on stone as well?
Thinking about using Thiox Fast Cure to construct plywood dinghies with my students. Two things: How are the fumes from this product? And, how long of a bead can I expect to get from a tube?
There isn't much smell. A 1/4" bead will do about 15 linear feet in the 185 ml tube.
Excellent product,worked very well for my chosen application
The only that I didn't like is that the flow of liquid is hard to control as it comes out of the tube.
Thixo products are great, but application varies.
Great end of result product application from the applicator is not always easy sometimes it flows well other times it's like buying a wasted tube of epoxy product may need a shelf life date
Works as Advertised
Works well when used as directed. Tubes are useable to the last drop.
Good stuff - will get more
Tried Thixo as an experiment. Used it to glue up a small birds mouth spar. No mess, no fuss - it just worked. My shop was close to the recommended 55 degrees limit, so it took a little longer than 4 hours to get hard enough to sand. But overnight, it was hard as a rock and ready to roll.Came out of the tube the consistency of Vasaline. Dried about the same color but not a problem since the joints in this application are internalI think I'll try Thixo Wood next.
All and all was impressed with product. Equally impressed with the help I recieved from techs on this product. Again Jamestown stands behind their products. Plan to use this again. In this application I used it as a glue to adhere glass panels togetherAnd then glass over them worked great.
Thixo Pro Amazing
Used this product to repair hard to reach transom wooden section!