AwlGrip Ultra Build Converter D3018
This item is eligible for free shipping
This item will require additional time to ship
AwlGrip Ultra Build Converter D3018 is a two-component epoxy primer with excellent sag resistance and excellent film build/filling capability. For use where high build and filling is required above the waterline. *** FOR PROFESSIONAL USE ONLY ***
This product should only be applied over other properly prepared Awlgrip Primers.
Mixing and Reduction - Mix by volume one part D8008 with one part D3018 to a smooth homogenous mixture. Reduce 5%-25%with T0073 for conventional spray, but airless spray requires no reduction.
Application Instructions - Apply in smooth, even coats, allow one hour between coats at 77 F/50% RH.
Note: Do not apply more than 2 coats without allowing to cure hard, 12 to 24 hours. Do not apply paint materials to surfaces warmer than 105 F or colder than 55 F. 0
Technical Information
- Type: Epoxy Polyamide
- Packaging: Available in 1 gallon and 1 quart containers
- Theoretical Coverage: Sq. Feet/Gallon 946 Sq. Feet at one mil dry
- 47-63 Sq. Feet at recommended dry film thickness
- Calculated for mixed base and converter reduced 10%. Coverage calculations are based on theoretical transfer efficiency of 100%.
- Actual coverage rate obtained will vary according to equipment choice, application techniques, part size, and application environment.
- Recommended Wet Film Thickness: 25-30 mils (625-750 microns)
- Recommended Dry Film Thickness: 15-20 mils (375-500 microns)
- Recoatability: May be overcoated with 545 Primer, HIGH BUILD Primer, SPRAYABLE FAIRING Compound, AWL-FAIR® L.W., and AWL-QUIK®.
- Minimum with itself, 1 hour; other products, 12 hours. Maximum without sanding 24 hours. Sanding before overcoating with other products is recommended.
